ATMEL ATtiny13 I2C SPI ADC DIP8 ATTINY13A-PU SOP8 ATTINY13A-SSU USB-Micro Adapter Modul Arduino

Atmel ATTINY13A 8-Bit-AVR-Mikrocontroller IC Adapter © androegg

Atmel ATTINY13A DIP8 Mikrocontroller IC + USB Micro Adapter Set © androegg

Atmel ATTINY13A-PU DIP8 Mikrocontroller © androegg

Atmel ATTINY13A-SSU SOP8 Mikrocontroller IC © androegg

Atmel ATTINY13A 8-Bit-AVR-Mikrocontroller wie folgt verfügbar:

• Adapter + DIP8 IC
• ATTINY13A-PU DIP8 IC
• ATTINY13A-SSU SOP8 IC

Der ATTINY13A ist ein 8-Bit-AVR-Mikrocontroller von Atmel und verfügt über

• 1KByte systeminterner programmierbarer Programmspeicher Flash
• 64 Bytes In-System programmierbares EEPROM
• 64 Bytes interner SRAM

ATMEL ATTiny13A

Der ATTINY13A Microcontroller unterstützt bis zu

• 1 x I2C Schnittstelle
• 1 x SPI Schnittstelle
• 4 x ADC 10-Bit

Atmel ATTINY13A 8-bit AVR microcontroller available as follows:

• Adapter + DIP8 IC
• ATTINY13A-PU DIP8 IC
• ATTINY13A-SSU SOP8 IC

The ATTINY13A is an 8-bit AVR microcontroller from Atmel and features:

• 1KByte of system-internal programmable program memory Flash
• 64 bytes in-system programmable EEPROM
• 64 bytes of internal SRAM

Atmel Attiny13A

The ATTINY13A microcontroller supports up to

• 1 x I2C interface
• 1 x SPI interface
• 4 x ADC 10-bit

ATTINY13A Microcontroller Feature:

• High Performance, Low Power AVR® 8-Bit Microcontroller
• Advanced RISC Architecture
  • 120 Powerful Instructions
  • Most Single Clock Cycle Execution
  • 32 x 8 General Purpose Working Registers
  • Fully Static Operation
• Non-volatile Program and Data Memories
  • 1K Bytes of In-System Programmable Program Memory Flash, 10,000 Write/Erase Cycles
  • 64 Bytes In-System Programmable EEPROM, 100,000 Write/Erase Cycles
  • 64 Bytes Internal SRAM
  • Programming Lock for Self-Programming Flash Program and EEPROM Data Security
• Peripheral Features
  • 8-bit Timer/Counter with Prescaler and Two PWM Channels
  • Programmable Watchdog Timer with Separate On-chip Oscillator
  • Programmable Dead Time Generator
  • USI – Universal Serial Interface with Start Condition Detector
  • 10-bit ADC – 4 Single Ended Channels
  • On-chip Analog Comparator
• Special Microcontroller Features
  • debugWIRE On-chip Debug System
  • In-System Programmable via SPI Port
  • External and Internal Interrupt Sources
  • Low Power Idle, ADC Noise Reduction, and Power-down Modes
  • Enhanced Power-on Reset Circuit
  • Programmable Brown-out Detection Circuit with Software Disable Function
  • Internal Calibrated Oscillator
• I/O and Packages
  • 8-pin PDIP/SOIC: Six Programmable I/O Lines
• Low Power Consumption
  • Active Mode: 1 MHz, 1.8V: 190 µA
  • Idle Mode: 24 µA at 1.8V