ESP8266 ESP-01  ESP-01S 8Mbit Flash WIFI WLan serial Modul 2.54 mm

Original ESP-01 Version 2017 © androegg

ESP8266 ESP-01 Pins with 2.54 mm Pitch © androegg

ESP-01 Basic Pin assignment © androegg

ESP-01 Pinout © androegg

ESP8266 ESP-01  mit 8Mbit Flash wie folgt verfügbar:

• ESP-01 mit 2 LED’s  (Spannungsversorgung rote LED und TX Status blaue LED )
• ESP-01S  mit 1 LED (TX Status blaue LED) 3 PullUp Widerständen (RST, GPIO0, CH_PD)

ESP8266 ESP-01 mit 2,54 mm Picth

Der ESP-01 verfügt über die Standard AT Firmware

ESP8266 ESP-01 with 8Mbit Flash available as follows:

• ESP-01 with 2 LED’s (Power Supply red LED and TX Status blue LED)
• ESP-01S with 1 LED (TX Status blue LED) and 3 PullUp Resistors (RST, GPIO0, CH-PD)

ESP8266 ESP-0S with 2.54 mm pitch

The ESP-01 comes with standard At Firmware.

ESP-01 Features:

• CPU / MPU:
  • Frequency: 80 / 160 MHz.
  • Risk: 32-bit
  • Instruction Ram: 64 Kb
  • Data Ram: 96 Kb
• SPI Flash:
  • Flash memory: 8Mb
  • Page program: up to 256 bytes in 0.7ms (TYP)
  • Deep power-down: 5μA (MAX)
  • Write Cycles: > 100,000 write cycles per sector
    Data retention: > 20 Years
• 802.11 b/g/n protocol
• supports Wi-Fi Direct (P2P)
• soft-AP Integrated TCP/IP protocol stack
• integrated PCB Antenna
• +19.5 dBm output power in 802.11b mode
• Power down leakage current of < 5uA
• Integrated low power 32-bit MCU
• supported Interface
  • SDIO 2.0
  • SPI
  • UART
  • STBC
  • MIMO
• A-MPDU & A-MSDU aggregation & 0.4μs guard interval
• Wake up and transmit packets in < 2ms
• Standby power consumption of < 1.0mW (DTIM3)